How to Use ip Command in Linux – Guide

The ip command can be used to change the routing, devices, and tunnels on a network. It is comparable to the ifconfig command, but is much more robust.

Configuring and updating default and static routing, setting up tunnel over IP, listing IP addresses and property information, modifying interface state, assigning, removing and configuring up IP addresses and routes are some of the other things it can do.

How to Knife

This option is used to show all associated IP addresses on all network devices. If we want to view information for any particular interface, add the show options followed by the name of the specific network interface.

It is used to display link layer information, it will fetch characteristics of currently available link layer devices. Any network device that has a driver loaded can be classified as an available device. ip link This link option when used with the -s option is used to show statistics for the various network interfaces. ip-s link And to get information about a specific network interface, add the show option followed by the name of the specific network interface.

-route: This command helps you see the route packets your network will take as defined in your routing table. The first entry is the default route. IP route

This command assigns an IP address to the development interface.

  • del: This deletes an IP address from an interface. ip to del (ip_address) interface dev

-down: This option disables a network interface. set of ip links (interface) down

-up: This option enables a network interface. ip link set (interface) up

-monitor: This command can continuously monitor and display the state of devices, addresses and routes.

This command is used to learn more about the ip command.

This command is used to view the MAC address of devices connected to your system.

This means that the neighbor is valid, but is probably unreachable. The kernel will try to check it on the first transmission.

This means that the neighbor is a valid and reachable person.

This means that a packet has been sent to the stable neighbor and the kernel is waiting for a response.

A hacker could modify ARP entries to cause a computer on the network to resolve an address that is not the intended destination. This could allow them to access resources or even take control of a system.

show ip address (interface) 192.168.1.1

To view information about a specific network interface, use the show option followed by the name of the specific network interface. ..

ip -s show interface

Final note

How to Use ip Command in Linux In this guide, we will be discussing how to use the ip command in linux. This command is used to list all the hosts and networks on a system. Additionally, this command can be used to view or change the IP address of a host or network. ip addr show This command will list all the hosts and networks on your system. You can also use this command to change the IP address of a host or network. To do so, you need to use the following syntax: ip addr add